Table of Contents
Advertisement
Installing the Wavion WBS-2400 Metro Base Station
Connecting Power
The following describes how to connect the WBS-2400 to power. There are three options for
connecting the Wavion WBS-2400 to a power source:
AC power source (3-wire service) — 3W(P+N+PE) or 3W(2P+PE); 110-220 VAC, 50/60
•
Hz.
Chapter 7: Installation Accessories
NEMA plug, for streetlight photoelectric control power tap (2-wire service) —2W(2P) or
•
2W(P+N); 100-240 VAC 50/60 Hz
for details.
DC power source (2-wire service); 48VDC See
•
page
55
for details.
Wavion injector connected to Ethernet port B (ETH B). See
•
Accessories
on page
W
ARNING
breaker to the circuit you plan to work on. Post a sign on the service panel so nobody
tries to reconnect power while you are working on the circuits. Double-check the
circuit with a circuit tester before you touch it to make sure the correct breaker has
been disconnected.
C
AUTION
continuity check between the WBS-2400 and the ground termination point to
confirm. You must also ground the outdoor data protection device to a ground rod or
a bonded pipe. Make sure you have completed grounding before you connect power
to the WBS-2400.
Connecting to AC Power (Category C)
The AC power connections for a Category C AC power source are shown in
W
ARNING
connections must conform to local uniform building codes.
28 Wavion
55
for details.
:
Turn the power off before working on an electrical circuit. Turn off the
:
You must always install an external grounding wire. Perform a simple
:
All wiring should be performed by a licensed electrician. All wiring and
on page
55
for details.
. See
Chapter 7: Installation Accessories
Chapter 7: Installation Accessories
on page
Chapter 7: Installation
Figure
55
on
3.19.
Hide quick links:
Advertisement
Table of Contents
