Safety Precautions; Mounting Strategies - Wavion WBS-2400-POE-FCC Installation Manual

C
AUTION
the outdoor data protection device to a bonded pipe or ground rod. Perform a simple
continuity check between the WBS-2400 and the ground termination point to
confirm. Make sure that grounding is complete before you connect power to the
Wavion WBS-2400.

Safety Precautions

Installing the Wavion WBS-2400 can be very hazardous. Take precautions to avoid the
following:
Exposure to high voltage lines
•
Contact with AC wiring
•
Injuries from dropped tools and equipment
•
Falls when working at heights or with ladders
•

Mounting Strategies

Consider the available mounting structures and antenna clearance when choosing a
mounting location. The Wavion WBS-2400 should always be mounted with the top of the unit
parallel to the ground, and with the antennas pointing upward and clear of obstruction.
It is recommended to attach ground and data cables to the WBS-2400 prior to mounting.
Before mounting the WBS-2400, read the wiring instructions in
2400 on page 23
N :
OTE
antennas to eliminate potential interference from the mounting structure.
Figure 3.1. demonstrates acceptable options for mounting on a streetlight. In both cases the
WBS-2400 is mounted to ensure clearance for the antennas above the height of the
streetlight.
:
You must always install an external grounding wire. You must also ground
and Connecting a Data Port
The WBS-2400 should be mounted with at least 4 ft of clearance around the
Installing the Wavion WBS-2400 Metro Base Station
on page 34.
Antennas clear of any
obstruction
Grounding the Wavion WBS-
Installation Guide 13