Connecting Power - Wavion WBS-2400 Installation Manual

Figure 3.18 Connecting the Antennas
W
connected.
W
unit.
W
You will most likely damage the antenna.
The successful insertion of six antennas should look as follows.

Connecting Power

The following describes how to connect the WBS-2400 to power. There are three options for
connecting the Wavion WBS-2400 to a power source:
• AC power source (3-wire service) -- 3W(P+N+PE) or 3W(2P+PE); 110-220 VAC, 50/60 Hz.
See Installation Accessories
:
ARNING Only connect the unit to the power supply once all the antennas are
:
ARNING Use caution when connecting the antennas. Undue haste can damage the
:
ARNING Do not screw in the antenna when holding the top section of the antenna.
on page 59 for details.
Installation Guide 29