Backhaul Unit Installation Instructions - Wavion WBS-2400-POE-FCC Installation Manual

Backhaul Unit Installation Instructions

This chapter describes how to install a backhaul unit with the WBS-2400.
Use the assembly equipment provided with the backhaul unit to install. Wavion does not
provide brackets or mounting equipment for the backhaul unit. Make sure the WBS-2400 is
installed in a higher position then the backhaul unit so the antennas are unobstructed. If the
backhaul unit is powered externally, connect to either ETH A, ETH B, or ETH C port. If the
backhaul unit is not powered externally, connect to either ETH A or ETH B port, according to
the backhaul input voltage.
W
ARNING
backhaul unit.
N :
OTE
unit
: Disconnect power to the WBS-2400 before connecting the
Make sure to use the correct Wavion part number for each backhaul
C
H A P T E R
Installation Guide
9
63