Using Hose Clamps; Mounting On A Pole, Or Streetlight - Wavion WBS-2400-POE-FCC Installation Manual

Installing the Wavion WBS-2400 Metro Base Station
Figure 3.1. Example Mounting Locations on a Streetlight

Using Hose Clamps

Hose clamps are used by the mounting assembly to secure the WBS-2400 to the mounting
structure. Figure 3.2
threaded through slots in the pole bracket, and then attached to either a vertical or a
horizontal pole and tightened.
There are three slots inside the pole bracket that can used to thread each hose clamp.
Choose the slot that is appropriate for the size of the pole.
Bands threaded
through inner
slots
Figure 3.2. Using Hose Clamps

Mounting on a Pole, or Streetlight

The following explains how to mount the Wavion WBS-2400 on a pole, tower, or streetlight.
It is recommended to mount the WBS-2400 on aluminum or galvanized steel structures.
N :
OTE
the ground and with the antennas pointing upward.
N :
OTE
Wavion WBS-2400
N :
OTE
the unit. Check the national electrical codes in your area for specific rules.
14 Wavion
demonstrates how to correctly use the hose clamps. The bands must be
The Wavion WBS-2400 must be mounted with the top of the unit parallel with
Before mounting the WBS-2400, read the wiring instructions in
on page 23
Mounting to wood, concrete, or painted poles requires primary grounding for
and Connecting a Data Port
Grounding the
on page 34.