Connecting Antennas - Wavion WBS-2400-POE-FCC Installation Manual

Connecting Antennas

This section explains how to connect the six antennas to the WBS-2400. In order for the
WBS-2400 to work properly, six antennas must be connected.
Screw each of the 6 antennas into the an N-Type connectors on the WBS-2400.
Figure 3.18. Connecting the Antennas
W
ARNING
connected.
W
ARNING
unit.
W
ARNING
You will most likely damage the antenna.
The successful insertion of six antennas should look as follows.
:
Only connect the unit to the power supply once all the antennas are
:
Use caution when connecting the antennas. Undue haste can damage the
:
Do not screw in the antenna when holding the top section of the antenna.
Installing the Wavion WBS-2400 Metro Base Station
Installation Guide 27