Connecting To Streetlight Power (Category C) - Wavion WBS-2400-POE-FCC Installation Manual

Connecting to Streetlight Power (Category C)

The following describes the power connections for Category C streetlight power. For outdoor
lighting commonly used by utilities, use the 3-prong NEMA twist-lock adapter with twist-lock
style photoelectric controls. The street light adapter uses a 3-pronged NEMA twist-lock
adapter that is installed between the outdoor lighting control and its fixture. The NEMA twist-
lock adapter is designed to be used with UL 773 listed outdoor lighting controls operating
with the following:
NEMA plug, for streetlight photoelectric control power tap (2-wire service) —2W(2P) or
2W(P+N); 100-240 VAC 50/60 Hz. See
details.
Figure 3.21. Connecting Streetlight Power
W
ARNING
powered by 100
lighting controls powered by higher voltage.
W
ARNING
To conne ct a st re etl ight powe r source
Verify that the service voltage is the following:
1.
NEMA plug, for streetlight photoelectric control power tap (2-wire service) —2W(2P) or
•
2W(P+N); 100-240 VAC 50/60 Hz. See
details.
Make sure that the power is turned off on the designated circuits.
2.
Remove the photosensor from the streetlight.
3.
Connect the NEMA 3 prong plug from the Wavion WBS-2400 to the photosensor connector
4.
on the streetlight.
Connect the photosensor to the top of the NEMA 3 prong plug.
5.
Connect the AC plug to the WBS-2400 and tighten by hand.
6.
:
Connect the WBS-2400 only to a twist-lock style outdoor lighting control
-240 VAC 50/60 Hz
:
Be extremely careful when connecting to Category C streetlight power.
Installing the Wavion WBS-2400 Metro Base Station
Chapter 7: Installation Accessories
. Do not connect it to twist-lock style outdoor
Chapter 7: Installation Accessories
on page
AC Power from
power adapter on
photosensor
on page
Installation Guide
55 for
55 for
31