YASKAWA DX200 Instructions Manual page 7

165626-1CD
JARCR-XFB01B Board
for DeviceNet
• Perform the following inspection procedures prior to conducting
manipulator teaching. If problems are found, repair them
immediately, and be sure that all other necessary processing has
been performed.
– Check for problems in manipulator movement.
– Check for damage to insulation and sheathing of external wires.
• Always return the programming pendant to the hook on the cabinet
of the DX200 after use.
The programming pendant can be damaged if it is left in the
manipulator's work area, on the floor, or near fixtures.
Read and understand the Explanation of Warning Labels in the DX200
Instructions before operating the manipulator:
• The wiring and mounting must be performed by authorized and
qualified personnel.
Failure to observe this caution may result in a fire or an electric shock.
• Make sure that there is no foreign matter such as metal chips on the
board.
In case of malfunction, etc. it may result in an injury or damage the
board.
• Make sure that there is no damage or deflection of parts on the
board.
In case of malfunction, etc. it may result in an injury or damage the
board.
• Correctly connect each cable and connector.
Failure to observe this caution may result in a fire or damage the board.
• Set the switches, etc. correctly.
Malfunction, caused by an incorrect setting, may result in an injury or
damage the board.
• Never touch the mounting surfaces of the board parts directly with
fingers.
The generated static electricity may damage the IC.
• Never touch the soldered surfaces of the board directly with fingers.
Protrusions on the soldered surface may result in an injury.
• No shock to the board.
The shock may damage the board.
vii
CAUTION
HW1481973
7/70