YASKAWA DX200 Instructions Manual page 46

JARCR-XFB01B Board
for DeviceNet
5 Allocating I/O Signals
5.3 DeviceNet Slave Allocation (Only in Master Mode)
7. Select {DETAIL}.
– The SCAN LIST window appears.
8. Select the desired item.
9. Enter the desired value.
– Set each parameter according to the actual status of the mounted
slave device.
Each item in the display indicates as follows:
MAC ID : Node address of the DeviceNet device
IN : Number of bytes to be input from the slave device
(1byte = 8 points)
OUT : Number of bytes to be output to the slave device
(1byte = 8 points)
TYPE : I/O message type of the slave device, POLL or
BITSTROBE. The message type "POLL" can be set for any
DeviceNet device.
"BITSTROBE" is only an input message and can be set for
a DeviceNet device of 8 bytes or less. For details of POLL
and BITSTROBE, refer to the DeviceNet specifications.
INTERVAL : Set the scanning interval of DeviceNet. It is displayed in the
same row as the master device number. Set to a value
between 10 ms to 300 ms in units of 1 ms. The default
setting is 30 ms.
5-23
165626-1CD
HW1481973
46/70