Show Ip Bgp Paths - Edge-Core ECS4620-28T Quick Start Manual

Table 27: show ip bgp - display description
Field
remote router ID
BGP state
Last read
hold time
keepalive interval
Neighbor capabilities
Message statistics
Minimum time
between
advertisement runs
For address family
Local host/port
Foreign host/port
Nexthop
Read thread
Write thread

show ip bgp paths

This command shows all paths in the database.
Syntax
Command Mode
Privileged Exec
Example
Description
IP address of the neighbor.
Stage of session negotiation.
Time since a message was last received from this neighbor.
Time to maintain the session with this neighbor without receiving a
message.
Interval at which keepalive messages are transmitted to this neighbor.
BGP capabilities advertised and received from this neighbor.
Statistics organized by message type.
Time between transmission of advertisements.
Address family to which the following information refers.
IP address and TCP port of the local BGP speaker.
IP address and TCP port of the neighbor BGP speaker.
IP address of next system via which packets are forwarded to the destination
network.
The read status for the socket connection with this neighbor.
The write status for the socket connection with this neighbor.
show ip bgp paths
Console#show ip bgp paths
Address RefCnt ASpath
0x331dad0:0 1
0x331d850:93 1 600
0x331d8d8:249 2 200 300
Console#
– 1129 –
Chapter 50
| IP Routing Commands
Border Gateway Protocol (BGPv4)
(Continued)