Pim Multicast Routing - Edge-Core ECS4620-28T Quick Start Manual

PIM Multicast Routing

IPv4 PIM Commands
This section describes the PIM commands used for IPv4 and IPv6. Note that PIM can
run on an IPv4 network and PIM6 on an IPv6 network simultaneously. Also note
that Internet Group Management Protocol (IGMP) is used for IPv4 networks and
Multicast Listener Discovery (MLD) for IPv6 networks.
Table 35: IPv4 and IPv6 PIM Commands
Command Group
IPv4 PIM Commands
IPv6 PIM Commands
This section describes commands used to configure IPv4 PIM-DM and PIM-SM
dynamic multicast routing on the switch.
Table 36: PIM-DM and PIM-SM Multicast Routing Commands
Command
Shared Mode Commands
router pim
ip pim
ip pim hello-holdtime
ip pim hello-interval
ip pim join-prune-holdtime
ip pim lan-prune-delay
ip pim override-interval
ip pim propagation-delay
ip pim trigger-hello-delay
show ip pim interface
show ip pim neighbor
PIM-DM Commands
ip pim graft-retry-interval
ip pim max-graft-retries
ip pim state-refresh
origination-interval
Chapter 51
Function
Configures multicast routing for IPv4 PIM.
Co figures multicast routing for IPv6 PIM.
Function
Enables IPv4 PIM globally for the router
Enables PIM-DM or PIM-SM on the specified interface
Sets the time to wait for hello messages from a
neighboring PIM router before declaring it dead
Sets the interval between sending PIM hello messages
Configures the hold time for the prune state
Informs downstream routers of the delay before it prunes a
flow after receiving a prune request
Specifies the time it takes a downstream router to respond
to a lan-prune-delay message
Configures the propagation delay required for a LAN prune
delay message to reach downstream routers
Configures the trigger hello delay
Displays information about interfaces configured for PIM
Displays information about PIM neighbors
Configures the time to wait for a Graft acknowledgement
before resending a Graft message
Configures the maximum number of times to resend a
Graft message if it has not been acknowledged
Sets the interval between PIM-DM state refresh control
messages
– 1165 –
| Multicast Routing Commands
PIM Multicast Routing
Mode
GC
IC
IC
IC
IC
IC
IC
IC
IC
NE, PE
NE, PE
IC
IC
IC