Router Pim - Edge-Core ECS4620-28T Quick Start Manual

Chapter 51
| Multicast Routing Commands
PIM Multicast Routing
PIM Shared Mode Commands

router pim

Table 36: PIM-DM and PIM-SM Multicast Routing Commands
Command
PIM-SM Commands
ip pim bsr-candidate
ip pim register-rate-limit
ip pim register-source
ip pim rp-address
ip pim rp-candidate
ip pim spt-threshold
ip pim dr-priority
ip pim join-prune-interval
clear ip pim bsr rp-set
show ip pim bsr-router
show ip pim rp mapping
show ip pim rp-hash
This command enables IPv4 Protocol-Independent Multicast routing globally on
the router. Use the no form to disable PIM multicast routing.
Syntax
[no] router pim
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
◆
This command enables PIM-DM and PIM-SM globally for the router. You also
need to enable PIM-DM or PIM-SM for each interface that will support multicast
routing using the ip pim dense-mode
make any changes necessary to the multicast protocol parameters.
◆
To use multicast routing, IGMP proxy cannot be enabled on any interface of the
device (see the ip igmp proxy
Function
Configures the switch as a Bootstrap Router (BSR)
candidate
Configures the rate at which register messages are sent by
the Designated Router (DR)
Configure the IP source address of a register message to an
address other than the outgoing interface address of the
designated router (DR) leading toward the rendezvous
point (RP)
Sets a static address for the rendezvous point
Configures the switch rendezvous point (RP) candidate
Prevents the last-hop PIM router from switching to
Shortest Path Source Tree (SPT) mode
Sets the priority value for a DR candidate
Sets the join/prune timer
Clears RP entries learned through the BSR
Displays information about the BSR
Displays active RPs and associated multicast routing
entries
Displays the RP used for the specified multicast group
or ip pim sparse mode
command).
– 1166 –
(Continued)
Mode
GC
GC
GC
GC
GC
GC
IC
IC
PE
PE
PE
PE
command, and