Triplett CamView IP Pro User Manual page 6

2
1.2.2 Standard Definition Analog Camera Test
The Tester can display the analog video signal input from an attached analog camera or video
source with NTSC or PAL format video output. The Tester can provide 12VDC (not to exceed 2.0
Amperes) to power the camera. If the camera has an RS485 port for PTZ control, the Tester can
be used to test that functionality. The Tester provides support for more than 30 PTZ command
formats.
1.2.3 Analog Video Test Pattern
You can select from several common video test patterns stored in the tester and generate stan-
dard definition analog (NTSC or PAL) format video output. These can be used to test cabling,
video recorders, and monitors. The selected video test pattern is displayed on the Tester's screen
along with the analog video input signal for simple visual comparison.
1.2.4 POE and DC Output
The Tester will automatically detect if a camera needs to be supplied with POE when an IP
camera is directly connected to Network Port 1 (i.e., the blue port). Network Port 2 always accept
POE power to test the POE output of installed PSE network devices. You may also use the Tester's
12VDC output jack to power analog cameras.
1.2.5 Audio Test
The Tester can be used to check audio signal functionality which is input on the Tester's audio
input jack.
1.2.6 Network Test
The Tester may be used to perform several Ethernet network test functions, including:
Network Sniff:
Monitors and displays Ethernet MAC IDs and IP addresses broadcast on the network
Subnet List:
Monitors and displays Ethernet MAC IDs and IP addresses broadcast on the selected
subnet according to IP and mask settings
Ping Test:
Performs the standard ping messaging response test on the specified destination IP
address
CamView IP Pro, Pro-C, and Pro+ User Manual