CamView IP Pro, Pro-C, and Pro+ User Manual
35
STEP 5: Run the Firmware Upgrade
If you have internet access, the Tester will automatically check for new firmware updates when
you initially land on the Check Upgrade screen. If, however, you see an error that states "Network
Failed" (see screenshot below), first confirm that the network you have plugged into does have
internet access and is set to DHCP. If the network does have internet access and the network is
supposed to be providing DHCP service to the Tester, you will need to press SET to get to the IP
Settings screen, and then just toggle over to "Static IP" and then back to "Use DHCP" by press-
ing the Right Arrow Key twice. Once "Use DHCP" is highlighted again, press
Iris+
to apply the
settings. The Check Upgrade should run immediately. The Tester will connect to the software up-
grade server and try to find a new software version automatically.
When a new version is found, the new version number and current version number will be dis-
Focus+
played. Press
to enter the download screen. The download process is fully automatic, and
an integrity check is automatically executed upon download completion. After this process, the
tester will return to the upgrade screen automatically.
An upgrade download may take seconds to dozens of minutes, depending on the network speed.
Please use a broadband connection to upgrade.This will save you valuable time.
After the update has successfully downloaded, a "Start Upgrade" prompt will be displayed on the
Zoom+
screen. Press
to start the upgrade. The system will reboot automatically then enter the
upgrade screen. Press SET to start. Follow the on-screen prompts to continue the process.
NOTES — Confirm the battery level is at least 30%. It is a good choice to connect the charger
when upgrading to avoid power loss during the upgrade process. Also, do not open battery cover,
remove the battery, or press the Reset button while upgrading as doing so may cause system
failure, and the device may not be able to boot up again.
Need help?
Do you have a question about the CamView IP Pro and is the answer not in the manual?