Input Wiring - IDTECK LX006 User Manual

7.5.3 INPUT WIRING

 External LED Control Connection
Connect the LED Control Input wire (Blue wire with White stripe) to the NO port of controller relay
output, and GND to the COM port. Set I/O of the controller; then you can control tuning on and off the
green LED. While the LED control is working, the green LED stays on.
The controller can use the I/O setting to set the LED controller so that it displays the additional LED
status for authorized/unauthorized access. For more information about the I/O setting of the controller,
refer to the controller's user manual.
 External Buzzer Control Connection
Connect the Buzzer Control Input wire (White wire with Red stripe) to the NO port of controller relay
output, and GND to the COM port. Set I/O of the controller; then you can generate beep sound. While
the buzzer control is working, the product keeps sounding beep.
The controller can use the I/O setting to set the buzzer controller so that it sounds the additional beep
for authorized/unauthorized access. For more information about the I/O setting of the controller, refer
to the controller's user manual.
 External Input Device Connection (System Operating Mode Change through External Input)
Connect the System Mode Control wire (Gray wire with Red stripe) to the NO port of controller relay
output, and GND to the COM port. Set I/O of the controller; then you can control the system mode.
While the system mode is controlled, RF Only mode is operated.
With I/O or time schedule setting, the controller can switch system operation mode in a specific time
section. For more information about the I/O setting of the controller, refer to the controller's user
manual.
Buzzer Control
White with Red stripe
LED Control
Blue with White stripe
System Mode Control
Gray with Red stripe
12V GND
POWER
(Figure: Input Connection)
19