Expansion Card Setup - Supermicro 2028UT-BC1NRT User Manual

SUPERSERVER 2028UT-BTNRT/BC1NRT User's Manual
6-4

Expansion Card Setup

Each node supports two PCI Express full height, half length expansion cards and
one MicroLP card. It uses a riser card and bracket.
Installing an Expansion Card
1. Disconnect the chassis from any power source.
2. Confirm that you have the correct expansion card, riser card and expansion
card bracket for the chassis.
3. Remove the PCIe slot covers at the rear of the chassis.
4. Secure the riser card onto the bracket with screws.
5. Insert the expansion card into the expansion slot on the riser card.
6. Place the expansion card bracket into the chassis as shown on the
following page, while inserting the riser card into its appropriate slot on the
serverboard.
7. Secure the expansion card bracket to the chassis with the three screws
provided.
Figure 6-6. Rear Expansion Card Slots
6-6
PCIe Slots