Installing The Outer Rails Onto The Rack - Supermicro 2028UT-BC1NRT User Manual

Installing the Outer Rails onto the Rack

Installing the Outer Rails
1. Press upward on the locking tab at the rear end of the middle rail.
2. Push the middle rail back into the outer rail.
3. Hang the hooks on the front of the outer rail onto the square holes on the
front of the rack. If desired, use screws to secure the outer rails to the rack.
4. Pull out the rear of the outer rail, adjusting the length until it just fits within the
posts of the rack.
5. Hang the hooks of the rear section of the outer rail onto the square holes on
the rear of the rack. Take care that the proper holes are used so the rails are
level. If desired, use screws to secure the rear of the outer rail to the rear of
the rack.
6. Repeat for the other outer rail.
1
1
1
2
Figure 3-5. Extending and Mounting the Outer Rails
Stability hazard. The rack stabilizing mechanism must be in place, or the rack
must be bolted to the floor before you slide the unit out for servicing. Failure to
stabilize the rack can cause the rack to tip over.
Do not use a two post "telco" type rack.
L-min=676.00(26.61")(outer rail)
21D01
1
3
2-7
Chapter 2: Server Installation
1
4