Table of Contents
Advertisement
SUPERSERVER 6028TP-HC1R/HC1TR/HC1FR USER'S MANUAL
Add-on Card/Expansion Slot Setup
The SC827HQ+ chassis includes I/O slots for add-on cards and expansion cards.
Each side supports one low profile/half length add-on card for a total of four per
chassis, one per drawer.
Installing Add-on Cards (Figure 6-12)
1. Disconnect the power supply, lay the chassis on a flat surface, and open the
chassis cover.
2. Pull open the add-on card slot clip in the rear of the chassis.
3. Slide the temporary PCI slot shield toward the slot clip and remove the
temporary shield from the chassis.
4. Connect the add-on card to the riser card.
5. Secure the riser card to the serverboard tray using the riser card screw.
6. Slide the add-on card bracket into the rear add-on card slot and secure with
the add-on card bracket screws.
7. Close the add-on card slot clip.
Note: Under normal circumstances, the riser card and add-on card bracket are
not separated.
Figure 6-12. Installing the Low Profile Add-On Card
Add-on Card
Bracket
Add-on Card
Bracket Screws
Add-on Card
PCI Slot
Shield
6-14
Riser Card
Advertisement
Table of Contents
