ITech IT6322A User Manual page 26

"OFF" when the power supply is turned on. The recommend setting is
"OFF".
Out Param
This menu item is used for set up power whether save the last output
parameters. If you select "Keep", the power save the last time before the
shutdown of the output parameters. The next time after startup power output
parameter is still the last output parameters. If you select "Reset", the power
output for factory default output parameters.
Knob
This item enables ("On") or disables ("Off") the knob.
Buzzer
This item turns the beep sound for key presses "On" or "Off".
Communication
This item set the communication mode, optional communication interfaces are
RS232, GPIB, USB.



Memory Group
You can store up to 36 different operating states in a nonvolatile memory
space. All saved parameters are divided into four groups. They are
Grp1,Grp2,Grp3 and Grp4. Each group can save 9 different operating
states(1~9).
Command
This item set the communication protocol. Possible settings are SCPI,EXT1
and EXT2. Default setting is SCPI.
Return Meter
This item enable("Wait5Sec") or disable(OFF) the function to turn back to
meter state automatically. When select "Wait5Sec",the display on front panel
will automatically change to meter state under the condition of no operation
within 5S.
RS232 Communication Set
This item configures the baud rate for serial communication. Possible
values are 4800,9600,19200,38400,57600,115200.When operating the
power supply in remote mode, make sure that you configure idential baud
rate settings for the power supply and the computer.
Optional settings of parity bit for serial communication are NONE,ODD
and EVEN. Default setting is NONE.
GPIB
This item set the communication address for GPIB interface. Avaialble
range is 0-31.
USB
Select communication mode via USB interface.
Copyright © Itech Electronics Co., Ltd.
Function and Features
17