Polycom SoundStructure C16 Design Manual page 389

Command
set phone_flash "Phone
Out"
Description
This parameter enables or disables exit tone generation for the telephony
interface. If exit tones are enabled (1), then an exit tone is played whenever the
auto-hangup feature engages and disconnects the telephony interface. Entry
tones (see the phone_entry_tone_en parameter) and exit tones are typically
enabled to prevent a caller from entering or exiting a conference unannounced.
phone_flash Connect Or Disconnect Telephony Interface
Argument
Channel Type
Value Type
Read/Write Mode
Phys Chans
Virt Chans
Description
Setting this parameter disconnects the telephony interface then reconnects it
after a short delay. The amount of delay can be configured with the
phone_flash_delay parameter.
Examples
Response
val phone_flash "Phone
Out"
phone_flash_delay Set Flash Delay
Argument
Channel Type
Value Type
Read/Write Mode
Phys Chans
Virt Chans
Argument value
Virtual Channel
Void
Write-Only
Analog Telephony Output
Mono
Description
Flashes the phone interface associated with the virtual
channel "Phone Out" to -6dB. Note that the phone out
virtual channel name must be used, not the phone in
virtual channel name.
Argument value
Virtual Channel
Integer
Read/Write
Analog Telephony Output
Mono
Command Protocol Reference Guide
A - 47