Polycom RMX RMX 4000 Hardware Manual page 59

Polycom RMX 4000 Hardware Guide
5
On the card to be installed, move the ejector levers to their fully open
position.
6
Slide in the replacement RTM ISDN card.
7
Insert the card into the slot until the ejector levers touch the front
edge of the card cage.
8
Push the ejector levers to their fully closed position.
9
Tighten the captive screws on each side of the rear panel of the card,
securing the RTM ISDN card to RMX.
10 Connect the RJ-45 terminated PRI cables into any of the slots labeled
PRI1 - PRI12:
7 E1 or 9 T1 cables can be connected to each RTM ISDN card, up to a
total of 14 E1 or 18 T1 PRI cables when a maximum of two RTM ISDN
cards are installed.
PRI Cables
2-15