Tasman Networks 1002 Installation Manual page 61

Table 14 Common Symptoms and Actions (continued)
Symptom Cause
System fails to boot, and 1
stops at [Tasman Networks
Boot].
2
Action
T1000.Z file is 1 Connect your terminal to the Console port on the
non-existent or has Tasman Networks router.
become corrupt
2 Configure the modem for 9600/8/None, and no flow
Flash is corrupt. control.
3 Power cycle the Tasman Networks router continuously
by pressing the Enter key until you see the following
prompt:
[Tasman Networks Boot]
4 Type c, and press Enter.
5 The following prompts will be displayed. Type the
bolded entries and press Enter.
boot device: lnPci (Lower case "L", not "1".)
processor number: 0
host name: host
file name: "The path and file name on your tftp server
(e.g., tftpboot/NCM.Z)"
inet on ethernet (e): x.x.x.x:ffffff00 (This is the
system's Ethernet address:netmask.)
inet on backplane (b): Not needed.
host inet (h): x.x.x.x (The ip address of the tftp server.)
gateway inet (g): x.x.x.x (Your router's address- not
necessary in the same subnet.)
user (u): wind (This is a required field.)
ftp password (pw) (blank = use rsh): wind (This is a
required field.)
flags (f): 0x8a
target (tn): Tasman Networks
startup script (s): Not needed.
other (o): lnPci (This is a lowercase "L", not a "1".)
6 At this point, you will be at the Tasman Networks
prompt [Tasman Networks Boot]. Type @ and press
Enter. This will boot the system from the network.
7 Once the system is booted and you have logged in, you
must format the Flash by issuing the following
command:
file format NCM
8 When the format is complete, follow the upgrade
procedures to finish the process.
NOTE: Remember to connect to the TFTP server that
contains the T1000.Z file.
Installation Guide: 1002 and 1004 Routers
61
TiOS 8.0