Network Connections; Connecting The Ethernet Cable; Connecting The Wan Cable - Tasman Networks 1002 Installation Manual

Network Connections

Connecting the Ethernet Cable

Connecting the WAN Cable

The following sections describe how to connect various network cables to the Tasman
Networks Model 1002 and Model 1004 router.
The front panel on the router accommodates one LAN connections. Use a category 5,
twisted-pair Ethernet cable with RJ-45 connectors to connect to the LAN. Refer to Figure 6 on
page 24 to identify this cable.
Follow this procedure to connect the Model 1002 and Model 1004 to an Ethernet LAN network.
Connect the RJ-45 connector of a category 5 rated Ethernet cable to either the Ethernet 0
1
port on the back panel.
Connect the RJ-45 connector on the other end of the cable to the LAN port.
2
Make sure that the cable connectors are locked and secure in the ports. See Table 22 on page
67 for pinout information about this cable.
Figure 15 Connecting the Ethernet Cable
Ethernet LAN Port
The back panel accommodates up to two WAN (model specific) cables. Use 26 AWG (minimum)
category 5, twisted-pair cable with RJ-48C connectors for this interface. Refer to Figure 7 on
page 24 to identify this cable.
CAUTION: To reduce the risk of fire, use only number 26 AWG or larger UL Listed or CSA Certified
Telecommunication Line Cord for all network connections.
Follow this procedure to connect a WAN port to the network:
Insert the RJ-48C connectors on one end of one cable in the appropriate port on the
1
Service Provider's demarcation point.
Insert the RJ-48C connectors on the other ends of the cables in the WAN ports on the front
2
panel of the Tasman Networks router.
Make sure that the cable connectors are locked and secure in the ports. See Table 23 on page
67 for pinout information about this cable.
Fast Ethernet Port 0
Fast Ethernet Port 1
Installation Guide: 1002 and 1004 Routers
31
TiOS 8.0