Table of Contents
Advertisement
42
CHAPTER 4
Configuration
Configuring Drop and Insert Multiplexing
Installation Guide: 1002 and 1004 Routers
TiOS 8.0
To use this feature, WAN ports 1 and 2 must be active and licensed for use. Drop and insert
supports one-to-one mapping of 1 to 24 voice-carrying DS0s on the PBX interface to the
equivalent DS0s on the network port. The PBX is connected to WAN port 1 and the DS0s are
mapped to the carrier facility on WAN port 2.
In this example, DS0 channels 1-10 and 18-24 from WAN links 1 and 2 are configured for drop
and insert traffic. The remaining DS0 channels (11-17) are available for IP traffic.
Configure the drop_insert interface
The interface name can be a maximum of 8 characters.
host# configure interface drop_insert Tasman Networks
Configure the mode type
The mode type can be one of the following three values:
0
data only (default)
1
data and voice
2
voice only
host# configure interface drop_insert Tasman Networks mode 2 1
Note that "2" represents port 2. This is the only value that will be accepted. The "1"
represents the mode (data and voice) for which port 2 is configured.
Display interface drop_insert Tasman Networks
host# show interface drop_insert Tasman Networks
drop_insert Tasman Networks
-----------------------
number of links
Interface Mode: DATA AND VOICE MODE
Signaling Type: RBS
host#
Configure the link
The default value for timeslots is all (available). Signaling can be configured for:
1
RBS (default)
2
ISDN
host#
configure
interface/drop_insert
1-10,10-24 signaling 1
0
Tasman
Configuring Drop and Insert Multiplexing
Networks#
t1
1
2
timeslots
Advertisement
Table of Contents
