24
CHAPTER 3
Installation
Network Connection
Cables Required
Tools Required
Installation Guide: 1002 and 1004 Routers
TiOS 8.0
To successfully complete the installation, the router must be connected to a network. Before
you start the installation, make sure that a live network connection is available at the
installation site.
The Model 1002 and Model 1004 router ships with a Console cable. You will need to obtain
additional cables for your specific application. The following additional cables are required to
install the Model 1002 and Model 1004 router.
One or two RJ-45, male/male, category 5, 26 AWG (minimum), twisted-pair,
■
straight-through cable (Ethernet LAN connection)
See Table 22 on page 67 for cable pinout information.
Refer to Figure 6 on page 24 to identify this cable.
Figure 6 Ethernet Cable
One or two RJ-48C, male/male, category 5, 26 AWG (minimum), twisted-pair,
■
straight-through WAN cable
See Table 23 on page 67 for cable pinout information.
Refer to Figure 7 to identify this cable.
Figure 7 WAN Cable
The following tools are required to install the Tasman Networks Model 1002 and Model 1004
router.
Figure 8 Required Tools
#2 Phillips screwdriver
#3 Phillips screwdriver
Site Preparation
1/4 inch flat blade screwdriver