Boot Process - Tasman Networks 1002 Installation Manual

46
CHAPTER 4
Configuration

Boot Process

Installation Guide: 1002 and 1004 Routers
TiOS 8.0
When power is applied to the Tasman Networks system, the Flash is checked for a
downloadable boot image. If a boot image file is found in the Flash, the file is executed.
Otherwise, the boot image is executed from the factory image stored in the boot ROM. Next,
the Tasman Networks operating system is loaded from the T1000.Z file residing in the Flash.
Power-up diagnostics such as flash test, memory test, etc. are run and then the Ethernet and
WAN interfaces are installed. The router is then configured using settings previously saved in
the system.cfg file. Once these settings are configured, the router is ready for operation and
user login.
Boot Process