Rack-Mount Installation - Tasman Networks 1002 Installation Manual

30
CHAPTER 3
Installation

Rack-Mount Installation

Installation Guide: 1002 and 1004 Routers
TiOS 8.0
To mount the Model 1002 and Model 1004 in an equipment rack, follow this procedure. Refer to
Figure 14.
Figure 14 Rack Mounting the Model 1002 and Model 1004 Router
Determine the mounting position for the rack tray in the equipment rack (front or mid
1
mount) and attach the mounting brackets using the four (provided) 6-32 x .250 inch flat
head Phillips screws.
Attach the router to the carriage assembly using four (provided) Phillips pan head 4-40 x
2
.250 inch screws.
Engage the carriage assembly in the rack tray rails and slide the assembly all the way in.
3
Fit the AC strap over the power supply and then place the power supply on the rack tray
4
between the raised tab and the back edge of the tray.
Engage and tighten the AC strap captive screw to secure the power supply to the rack
5
tray.
Attach the cable retainer bracket to the DC power cord behind the molded strain relief on
6
the cable.
Insert the power cable jack into the 12 VDC port on the back of the router.
7
Engage and tighten the captive screw on the cable retainer bracket in the threaded hole
8
adjacent to the DC input jack on the router.
Coil the excess cable and secure it on the tray behind the router.
9
Mount the tray in the equipment rack using either four (provided) Phillips pan head 10-24
10
x .5 inch screws or four (provided) Phillips pan head 12-32 x .5 inch screws, whichever fits
the equipment rack.
Connect the network cables to the router. Secure the cables in the clips located on the
11
bottom of the carriage assembly. Refer to Network Connections on page 31.
Connect the appropriate ends of the AC cord to the secured power supply and a 110/120
12
VAC outlet.
Using a small flat blade screwdriver, engage and tighten the captive screw to secure the
13
carriage assembly to the rack tray.
Installing the Model 1002 and Model 1004 Router