Table of Contents
Advertisement
user [u]
Make sure to type wind. Then set the password also to wind. Press the Enter key.
16
The following text is output to the terminal:
ftp password [pw] [blank = use rsh] : wind
Set the flags. Type 0x8a. Press the Enter key.
17
The following text is output to the terminal:
flags [f]
: Ox8a
Set the target name. Press the Enter key.
The following text is output to the terminal:
target name [tn]
:T1000
The name that you use to configure the Tasman Networks router will become the system prompt.
Ensure that the startup script parameter is blank. The "other" parameter may be blank or left as
"inPci."
After entering all the parameters described above, the Tasman Networks boot prompt, "[Tasman
Networks Boot]" is displayed.
Verify that the settings are correct. Press the Enter key to display the following text:
18
[Tasman Networks Boot]: P
boot device
unit number
processor number
host name
file name
1net on ethernet [e]
host 1net [h]
gateway 1net [g]
user [u]
ftp password [pw]
flags [f]
target name [tn]
ether [e]
[Tasman Networks Boot]:
Type @ and press the Enter key to boot from the network.
19
Download the new images. Refer to Upgrading Software on page 48.
20
: wind
:
InPci
: 0
: 0
: host
:
tftpdir/8.0/T1000.Z
:
10.1.0.1:fff0000
:
10.11.12.13
: 111.2.3.254
: wind
: ****0
: 0x8a
: T1000
: InPci
Installation Guide: 1002 and 1004 Routers
51
TiOS 8.0
Advertisement
Table of Contents
