Installing The Model 1002 And Model 1004 Router - Tasman Networks 1002 Installation Manual

28
CHAPTER 3
Installation

Installing the Model 1002 and Model 1004 Router

Table Top Installation
Installation Guide: 1002 and 1004 Routers
TiOS 8.0
The Model 1002 and Model 1004 router can be installed on a table top, in a Telco equipment
rack (using the optional rack-mounting tray), or on a vertical surface (using the optional
wall-mounting assembly). The router ships with a Console cable. You will need to obtain
additional cables for your specific application. Refer to Figure 6 and Figure 7.
CAUTION: Do not block the cooling vents on the top of the unit.
NOTE: For problem-free operation, the router should be located in an area with adequate ventilation.
To install the Model 1002 and Model 1004 for operation on a table top, follow this procedure.
Refer to Figure 12.
Figure 12 Table Top Installation
110/120 VAC Outlet
Place the unit on the table surface.
1
Insert the DC power cable into the DC input jack on the front of the unit.
2
Attach the cable retainer bracket behind the molded strain relief on the power supply
3
cable near the DC input jack.
Engage and secure the captive screw on the retainer in the threaded hole adjacent to the
4
input jack on the router.
Connect the appropriate ends of the AC power cord to the power supply and a
5
110/120 VAC outlet.
Ensure that the cables are router out of the way of foot traffic.
NOTE:
Installing the Model 1002 and Model 1004 Router
Threaded Hole
12 VDC Port
Cable Retainer