Upgrading Software - Tasman Networks 1002 Installation Manual

48
CHAPTER 4
Configuration

Upgrading Software

Installation Guide: 1002 and 1004 Routers
TiOS 8.0
To upgrade the T1000.Z and T1000.bin files:
Download T1000.Z and T1000.bin from the Tasman Networks Support page on the website
1
and place it on a server that is running a TFTP daemon.
Ensure that network connectivity exists between the Tasman Networks system being
2
upgraded and the TFTP server holding the new file. Pinging the server from the Tasman
Networks system is a good method to use to prove connectivity.
Download files to the Flash. The general format for the download commands is:
3
file download server_ip source_file local_file
server_ip The IP address of the server holding the upgrade files.
source_file Path and file name of the file to be downloaded.
local_file File name to be used in local flash memory.
For example, a typical sequence might consist of:
downloading all files to the main board:
■
file/download 10.10.1.1 software/T1000.Z T1000.Z
file/download 10.10.1.1 software/T1000.bin T1000.bin
Move the .bin images to the downloadable boot area:
4
file/copy_boot T1000.bin
file/validate_boot T1000.bin (This should validate the copy_boot procedure.)
Make sure you are booting the images from the Flash and then reboot the system:
5
configure# boot T1000.Z
Then type "Y" to reboot the router.
After reboot, log in and verify the proper software version with the following command:
6
display version
Upgrading System Software