Table of Contents
Advertisement
Configuring Subinterfaces
When viewing the Network Information page, Subinterfaces are designated in
the Interface Information section with the device name and number, separated
by a colon (for example, eth0:100).
To configure subinterfaces, use the following steps:
1. Using the configuration graphical user interface, from the Configuration
Menu on the left-hand side, click Network.
2. Click Subinterfaces. The window shown below opens.
3. On this screen, complete the following information:
•
IP Address is the address to be assigned to the subinterface.
•
Netmask is the network mask to use for the address. If several addresses
are applied to an interface and these addresses are in a common network,
they must use a common subnet. The system does not support
supernetting.
•
Interface is the port where the subinterfaces will be configured.
4. When you have finished entering this information, click Add. The
following popup appears:
5. Click OK. The new subinterfaces entry appears on the Subinterfaces
window in the list area.
Configuring the V2IU 4350
3 - 27
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the V2IU 4350 and is the answer not in the manual?
Questions and answers