Details Of Input Signals - Mitsubishi Electric MELSEC iQ-R User Manual

Details of input signals

The following describes the details of the input signals for the flexible high-speed I/O control module which are assigned to the
CPU module.
The I/O numbers (X/Y) in this section apply when the start I/O number of the flexible high-speed I/O control module is set to
"0".
Module READY
This signal turns on when the control is ready after the CPU module is powered on or is reset.
In the following case, 'Module READY' (X0) turns off.
• When a watchdog timer error has occurred in the flexible high-speed I/O control module (The control is not performed.)
■Device number
The following shows the device number of this input signal.
Signal name
Module READY
Operating condition settings batch-reset complete flag
When the setting of the execution memory is reset with the value stored in the flash ROM in the flexible high-speed I/O control
module, this signal is used as an interlock to turn on or off 'Operating condition settings batch-reset command' (Y3).
• When 'Operating condition settings batch-reset command' (Y3) is turned on, this signal turns on. When the reset of the
hardware logic setting is completed with an error, this signal also turns on.
• When 'Operating condition settings batch-reset command' (Y3) is turned off, this signal turns off.
'Module READY' (X0)
'Operating condition
settings batch-reset
complete flag' (X3)
'Operating condition
settings batch-reset
command' (Y3)
User Address (monitor)
(Un\Gxx)
Value of the hardware logic
Value of the flash ROM
Performed in the flexible high-speed I/O control module
Performed in the program
■Device number
The following shows the device number of this input signal.
Signal name
Operating condition settings batch-reset complete flag
APPX
226
Appendix 2 I/O Signals
ON
OFF
OFF
ON
OFF
Monitor of setting A
Setting A
Setting B
Device number
X0
ON
Monitor of setting B
Setting B
Device number
X3