Mitsubishi Electric MELSEC iQ-R User Manual page 189

■Multi function counter block detail window
Block Variable name

Input 0

Event 0
Input_Signal_Event Detector Select
Detector Select
Counter_Timer_0 Count Enable
Count Mode
Upper Limit
Lower Limit
Clock
Add Mode
Add Value
STOP  PRESET
PRESET  STOP
Preset Value
Compare_0 Condition
Compare Mode A
Compare Value A

Set/Reset_0

Output 0
*1 Output ON time = Clock cycle setting  (Compare value - Preset value + 1)
*2 In the addition mode, the output ON time calculated from the following is applied.
Output ON time = (Clock cycle setting  (Compare value - Preset value + 1))  Addition value
The items other than the above need not to be set.
Setting value


User Setting (ON only in A: High)
User Setting (ON only in A: Rise)
ON
Linear
4294967295
0
1ms
OFF
0
ON
OFF
1
Coincidence
=
100


Description


Set this parameter to detect the phase A input signal.
Set this parameter to "ON".
Set this parameter according to the control.
Set this parameter according to the control.
Set this parameter according to the control.
Set this parameter according to the control.
Set this parameter according to the control.
Set this parameter to "ON", to perform a preset when a
stop event occurs.
Set this parameter to "OFF".
Set this parameter according to the control.
Set this parameter to "Coincidence".
Set this parameter to "=".
Set this parameter according to the control.


4 BLOCK LINK EXAMPLES
4.2 One-shot Timer
4
*1
*2
*1
*1
187