Mitsubishi Electric MELSEC iQ-R User Manual page 114

Window layout
The following describes the configurations of the "Pattern generator output pattern setting" window. Set the output pattern
data in this window.
To display the "Pattern generator output pattern setting" window, click "Detail" of the pattern generator block in the Multi
function counter block detail window (Counter_(16bit_Unsigned)).
• Set output patterns at the upper section of the window.
• The images of set output patterns are displayed at the lower section of the window.
The following table lists the items to be displayed in the "Pattern generator output pattern setting" window.
Item
Output pattern setting area
"Start"
"Display position" button
"Full display"
"Pattern clear" button
"Pattern image"
"Read from the file" button
"Save to File" button
"OK" button
"Cancel" button
2 FUNCTIONS OF THE CONFIGURATION TOOL
112
2.11 Pattern Generator Function
"Pattern selection"
"Points"
"0" to "8191"
Description
Specify the pattern number to be assigned to a pattern generator block.
Click the "OK" button to reflect the specified pattern number to "Pattern No." of the
pattern generator block.
Set the number of points that composes an output pattern. The default value is 0,
and 1 to 8192 can be set.
• When 0 is set, the corresponding output pattern is disabled.
• When 1 or larger number is set, the output patterns of the set number of points are
enabled.
Set the output pattern of the pattern generator block from "0: Low output" or "1: High
output" for each point number.
The default value is "0: Low output". Every time the cell is clicked, the output pattern
switches between "0: Low output" and "1: High output".
Output patterns can be set for the number of output pattern points set in "Points".
Set the start point to display the image of an output pattern.
Change the start position of the image of an output pattern displayed in the window.
Switch the display range of the image of an output pattern.
• Selected: Display the whole image with the range of the setting value in "Points".
• Not selected: Display the image of the 20 points displayed at the upper section of
the window.
Set "0: Low output" for all the selected output patterns.
Display the High/Low image of the selected output pattern from the start point.
Read the output pattern data saved in a CSV file to the "Pattern generator output
pattern setting" window.
Save the output pattern data in the "Pattern generator output pattern setting" window
into a CSV file.
Set the output pattern set in the "Pattern generator output pattern setting" window for
the hardware logic. The following items can be changed automatically according to
the output pattern.
• "Upper Limit" of "Counter_Timer_0"
• "Lower Limit" of "Counter_Timer_0"
To reflect the hardware logic where the output patterns have been set to the module,
write the data into module.
Close the "Pattern generator output pattern setting" window.
Output pattern setting area