Table of Contents
Advertisement
Magician LED
Control Modes
There are 5 modes:
One Magician (Auto Program and Static Color Mode)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Magician is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 18 and 19 for more information about Auto Program and Static Color Mode.
One Magician (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Turn on the music. If the device is set to sound-control, then the Magician will react to the beat of
the music. Please see page 18 for more information about the sound-control options.
Multiple Magicians (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-p XLR cable to connect the Magician and other devices.
The pins:
04) Link the units as shown in Fig. 05, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third and fourth units. You can
use the same functions on the master device as described on pages 18 and 19 (Auto, Static color).
This means you can set your desired operation mode on the master device and all slave devices will
react the same as the master device.
Multiple Magicians (Master/Slave control)
Ordercode: 43161
• Auto Program
• Static Color (manual)
• Sound-controlled
• Master/slave
• DMX-512 (3CH, 5CH, 11CH or 28CH)
1. Earth
2. Signal (-)
3. Signal (+)
13
Fig. 05
Advertisement
Table of Contents
