Panasonic KX-TDA100 Installation Manual page 163

2.
Pass the wires through the hole in the base cover, and attach the base cover to a wall
using 2 screws.
Screw
Note
Two kinds of screws are included with KX-T30865. Please choose the appropriate kind for
your wall type.
3.
Connect the wires to the screws located in the front cover.
4.
Re-attach the 2 halves and re-insert the screw.
Connection
Use 8-pin and 10-pin terminal blocks (included with the card) for connection.
1.
While pressing down on the hole at the top of the terminal block using a screwdriver, insert
the wire into the side hole as shown below. Repeat this procedure for other doorphones
and door openers.
Refer to "2.6.2 DPH4 Card" and "2.6.3 DPH2 Card" for pin assignments.
Doorphone
Door Opener
: when a doorphone plate has been fixed to the wall
: when you wish to install the doorphone directly to the wall
2.10 Connection of Doorphones and Door Openers
To 8-pin terminal block
To 8-pin terminal block
Installation Manual 163