2.9 Connection of 2.4 GHz Portable Stations
Connection of 2.4 GHz Portable Stations
The following equipment is required to connect the wireless system:
CSIF Card: CSIF8 (KX-TDA0144)
One CSIF8 card supports up to 8 Cell Stations. Up to 2 CSIF8 cards can be connected to the
KX-TDA100, and up to 4 can be connected to the KX-TDA200.
CS: Cell Station (KX-TDA0142)
This unit determines the area covered by the wireless system. Up to 3 calls can be made at
the same time through each CS.
PS: 2.4 GHz Portable Station (KX-TD7690)
The KX-TDA100 and KX-TDA200 can support up to 128 PSs. For more details about the PS,
refer to the PS Operating Instructions.
The CS should be kept free of dust, moisture, high temperature (more than 40 °C),
low temperature (less than 0 °C), vibration, and should not be exposed to direct
The CS should not be placed outdoors (use indoors).
The CS should not be placed near high voltage equipment.
The CS should not be placed on a metal object.
Systems using 2.4 GHz ISM (Industrial, Scientific and Medical) band may interfere
with the KX-TDA wireless system. Examples of such systems are cordless
telephones, wireless LAN, Home RF, microwave ovens and other ISM devices. These
systems may cause minor noise.
Keeping some distance between the equipment listed below may prevent
interference. (The distance may vary depending on the environment.)
Please take into consideration the distance between the CSs when site planning.
Please consult a certified dealer for details.
However, the required distance between CSs may vary depending on the
environment of the installation site and conditions in which the wireless system is
used. Conduct the site survey to determine the appropriate distance.
CS and office equipment such as a computer, telex,
fax machine, etc.
CS and PS
Hybrid IP-PBX and CS
CS and CS
More than 2 m
More than 1 m
More than 0.5 m
More than 2 m
More than 15 m