Panasonic KX-TDA100 Installation Manual page 174

2.13 Starting the Hybrid IP-PBX
2.
Plug the AC power cord into the Hybrid IP-PBX and an AC outlet, and turn on the Hybrid
IP-PBX.
Note
For safety reasons, do not stretch, bend, or pinch the AC power cord.
3.
Press the Reset Button with a pointed tool. (The RUN indicator will flash.)
4.
While the RUN indicator is flashing (within about 10 s), return the System Clear Switch to
the "NORMAL" position. Depending on the configuration, initialisation takes about 1 min
to 3 min. If successfully executed, the RUN indicator will stop flashing and be kept lit.
All data will be cleared, and the Hybrid IP-PBX as well as all optional service cards (except for
the IP-GW4 card) will be initialised to the default values. The DPTs should show the time as
01:00.
The data of the IP-GW4 card will not be initialised.
Notes
• Use only the AC power cord included with the Hybrid IP-PBX for the PSU.
• Use only the supplied AC power cord for the purpose of applying the EMC standard,
if the Hybrid IP-PBX is connected (Germany only).
LED Indications
Indication
RUN
ALARM
Confirming the Trunk Connection
After initialisation, programme the Hybrid IP-PBX and establish trunk connection, and then use
a PT to confirm it.
To confirm, dial [ ] [3] [7] + trunk number (3 digits) or press S-CO button (CO01 to CO64). You
will hear a dial tone if the trunk is available and connected.
174 Installation Manual
To AC Outlet
Colour Description
Green OFF: Power Off (includes normal reset)
ON: Power On and running (on-line)
Flash (60 times per minute): Power On and starting
Flash (120 times per minute): Power On and resetting before
system clear
Red OFF: Normal
ON: Alarm (CPU stop, alarm for each card)
Flash: Alarm (MPR file error in restarting)