E1 Card - Panasonic KX-TDA100 Installation Manual

Hybrid ip-pbx
Hide thumbs Also See for KX-TDA100:
Table of Contents

Advertisement

2.4.6

E1 Card

Function
1-port E1 trunk card. ITU-T standard compliant.
To NT1/Extension
To NT1/Extension
For BNC
Accessory and User-supplied Items
Accessory (included): ferrite core × 1
User-supplied (not included): RJ45 or BNC connector
Notes
In some countries/areas, this optional service card must not be connected to the
Public Switched Telephone Network.
When connecting this optional service card to the trunk, connect through NT1; do not
connect to the trunk directly.
Use only 1 type of connector (RJ45 or BNC) for connection; RJ45 and BNC cannot
be used simultaneously.
When connecting the RJ45 connector, attach the included ferrite core. Refer to "2.2.9
Attaching a Ferrite Core".
This optional service card can be used for either trunk or extension connection, by
setting the A/B switch or using the connector with appropriate pin assignments.
To confirm the trunk connection, refer to "Confirming the Trunk Connection" in "2.13.1
Starting the Hybrid IP-PBX".
CAUTION
E1 ports are SELV ports and should only be connected to SELV services.
LEDs
RJ45
For RJ45
120Ω
120Ω
OR
75Ω
75Ω
2.4 Installation of the Trunk Cards
BNC (TX) outer conductor
J 3 0 8
OR
3
1 2
For Frame
Ground Open
BNC (TX)
BNC (RX)
OR
BNC (RX) outer conductor
Installation Manual
J 3 0 8
3
1 2
For Frame
Ground Short
77

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-tda200

Table of Contents