Table of Contents
Advertisement
Common Configuration Tasks
Tunnel Egress Node
This configuration shows how the interface through which the IPv6 over IPv4 traffic leaves the
node. It must be configured on a network interface. Both the IPv4 and IPv6 system addresses must
be configured.
CLI Syntax: config>router
The following displays interface configuration.
A:ALA-49>configure>router# info
----------------------------------------------
...
----------------------------------------------
Page 56
configure router static-route ::C8C8:C801/128 indirect
200.200.200.1
interface ip-int-name
address {ip-address/mask>|ip-address netmask} [broad-
cast all-ones|host-ones]
ipv6
address ipv6-address/prefix-length [eui-64]
port port-name
interface "ip-1.1.1.2"
address 1.1.1.2/30
port 1/1/1
exit
interface "system"
address 200.200.200.2/32
ipv6
address 3FFE::C8C8:C802/128
exit
exit
7710 SR OS Router Configuration Guide
Advertisement
Table of Contents
