Table of Contents
Advertisement
link-local-address
Syntax
link-local-address ipv6-address [preferred]
no link-local-address
Context
config>router>if>ipv6
Description
This command configures the link local address.
local-proxy-nd
Syntax
[no] local-proxy-nd
Context
config>router>if>ipv6
Description
This command enables local proxy neighbor discovery on the interface.
The no form of the command disables local proxy neighbor discovery.
proxy-nd-policy
Syntax
proxy-nd-policy policy-name [policy-name...(up to 5 max)]
no proxy-nd-policy
Context
config>router>if>ipv6
Description
This command configure a proxy neighbor discovery policy for the interface.
Parameters
policy-name — The neighbor discovery policy name. Allowed values are any string up to 32
neighbor
Syntax
neighbor [
no neighbor [
Context
config>router>if>ipv6
Description
This command configures an IPv6-to-MAC address mapping on the interface. Use this command if a
directly attached IPv6 node does not support ICMPv6 neighbor discovery, or for some reason, a static
address must be used. This command can only be used on Ethernet media.
The ipv6-address must be on the subnet that was configured from the IPv6 address command or a
link-local address.
7710 SR OS Router Configuration Guide
characters long composed of printable, 7-bit ASCII characters. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes. The
specified policy name(s) must already be defined.
ipv6-address] [mac-address]
ipv6-address]
IP Router Configuration
Page 129
Advertisement
Table of Contents
