Table of Contents
Advertisement
Priority Policy Route Unknown Event Commands
bgp-vpn — This parameter defines bgp-vpn as an eligible route source for a returned route prefix
ospf — This parameter defines OSPF as an eligible route source for a returned route prefix from the
is-is — This parameter defines IS-IS as an eligible route source for a returned route prefix from the
rip — This parameter defines RIP as an eligible route source for a returned route prefix from the
static — This parameter defines a static route as an eligible route source for a returned route prefix
route-unknown
Syntax
[no] route-unknown prefix/mask-length
Context
config>vrrp>policy>priority-event
Description
This command creates a context to configure a route unknown priority control event that monitors the
existence of a specific active IP route prefix within the routing table.
The route-unknown command configures a priority control event that defines a link between the
VRRP priority control policy and the Route Table Manager (RTM). The RTM registers the specified
route prefix as monitored by the policy. If any change (add, delete, new next hop) occurs relative to
the prefix, the policy is notified and takes proper action according to the priority event definition. If
the route prefix exists and is active in the routing table according to the conditions defined, the event
is in the cleared state. If the route prefix is removed, becomes inactive or fails to meet the event
criteria, the event is in the set state.
The command creates a route-unknown node identified by prefix/mask-length and containing event
control commands.
Page 280
a returned route prefix with a source of BGP will not be considered a match and will cause the
event to enter the set state.
from the RTM when looking up the route-unknown route prefix. The bgp-vpn parameter is not
exclusive from the other available protocol parameters. If protocol is executed without the bgp-
vpn parameter, a returned route prefix with a source of bgp-vpn will not be considered a match
and will cause the event to enter the set state.
RTM when looking up the route-unknown route prefix. The ospf parameter is not exclusive
from the other available protocol parameters. If protocol is executed without the ospf
parameter, a returned route prefix with a source of OSPF will not be considered a match and will
cause the event to enter the set state.
RTM when looking up the route-unknown route prefix. The is-is parameter is not exclusive
from the other available protocol parameters. If protocol is executed without the is-is parameter,
a returned route prefix with a source of IS-IS will not be considered a match and will cause the
event to enter the set state.
RTM when looking up the route-unknown route prefix. The rip parameter is not exclusive from
the other available protocol parameters. If protocol is executed without the rip parameter, a
returned route prefix with a source of RIP will not be considered a match and will cause the
event to enter the set state.
from the RTM when looking up the route-unknown route prefix. The static parameter is not
exclusive from the other available protocol parameters. If protocol is executed without the
static parameter, a returned route prefix with a source of static route will not be considered a
match and will cause the event to enter the set state.
7710 SR OS Router Configuration Guide
Advertisement
Table of Contents
