Table of Contents
Advertisement
Configuration Commands
Filter policies control packet forwarding and dropping based on IP match criteria.
The ip-filter-id must have been pre-configured before this filter command is executed. If the filter ID
does not exist, an error occurs.
Only one filter ID can be specified.
The no form of the command removes the filter policy association with the IP interface.
Default
No filter is specified.
Parameters
ip ip-filter-id — The filter name acts as the ID for the IP filter policy expressed as a decimal integer.
ipv6 ipv6-filter-id — The filter name acts as the ID for the IPv6 filter policy expressed as a decimal
Page 122
The filter policy must already exist within the config>filter>ip context.
Values
1 — 16384
integer. The filter policy must already exist within the config>filter>ipv6 context.
Values
1— 65535
7710 SR OS Router Configuration Guide
Advertisement
Table of Contents
