Alcatel 7710 SR OS Configuration Manual page 191

Parameters
ip-address — Only displays the interface information associated with the specified IP address.
ip-int-name — Only displays the interface information associated with the specified IP interface name.
packet
Syntax packet [ip-int-name | ip-address] [headers] [protocol-id]
no packet [ip-int-name | ip-address]
Context debug>router>ip
Description
This command enables debugging for IP packets.
Parameters
ip-int-name — Only displays the interface information associated with the specified IP interface name.
ip-address — Only displays the interface information associated with the specified IP address.
headers — Only displays information associated with the packet header.
protocol-id — Specifies the decimal value representing the IP protocol to debug. Well known protocol
route-table
Syntax route-table [ip-prefix/prefix-length]
route-table ip-prefix/prefix-length longer
no route-table
Context debug>router>ip
Description
This command configures route table debugging.
7710 SR OS Router Configuration Guide
Values
ipv4-address
ipv6-address
Values
32 characters maximum
Values
32 characters maximum
numbers include ICMP(1), TCP(6), UDP(17). The no form the command removes the protocol
from the criteria.
Values
0 — 255 (values can be expressed in decimal, hexidecimal, or binary)
ipv6, ipv6-frag, ipv6-icmp, ipv6-no-nxt, ipv6-opts, ipv6-route, keywords: none, crtp,
crudp, egp, eigrp, encap, ether-ip, gre, icmp, idrp, igmp, igp, ip, ipv6, ipv6-frag, ipv6-
icmp, ipv6-no-nxt, ipv6-opts, ipv6-route, isis, iso-ip, l2tp, ospf-igp, pim, pnni, ptp,
rdp, rsvp, stp, tcp, udp, vrrp
* — udp/tcp wildcard
a.b.c.d (host bits must be 0)
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
IP Router Configuration
Page 191