Enter The Path When Wetted Selected - GE AquaTrans AT600 User Manual

4.7.11 Enter the Path when Wetted selected

Sensor Setup
Traverses
Fluid Type
Fluid Temperature
Path
Path
Path Length
Axial Length
Path
Path Length
0.000 mm
Path Length
UNIT: mm
0.000
]UNDO [ ]SAVE
]MOVE [ ]MODF
IMPORTANT: Changing the transducer spacing should only be completed according to instructions received
from the factory.
AquaTrans™ AT600 User's Manual
Path
Select and press [√]. The following screen opens.
In the Sensor Setup menu, select Path Length or Axial Length and press
[√]. A screen similar to the following opens.
Press [√] again. Enter this Path use in installing your transducers on the
pipe. The calculation is based on your
transducer, fluid, and traverses).
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press

save. Then, press [ ] to return to the previous screen.
Chapter 4. Initial Setup and Programming
Sensor Setup
input (pipe,

[ ] t
o
87