Proper Installation - US Water Systems Fusion Owner's Manual

3
This water softening system must be properly installed and located in accordance with the
Installation Instructions before it is used or the warranty will be void.
Do not install or store where it will be

exposed to temperatures below freezing or
exposed to any type of weather. Water
freezing in the system will break it. Do not
attempt to treat water over 100°F.
Do not install in direct sunlight. Exces-

sive sun or heat may cause distortion or
other damage to non-metallic parts.
Properly ground to conform with all gov-

erning codes and ordinances.
Use only lead-free solder and flux for all

sweat-solder connections, as required by
state and federal codes.
Maximum allowable inlet water pressure is

125 psi. If daytime pressure is over 80 psi,
night time pressure may exceed the maxi-
mum. Use a pressure reducing valve to

Proper Installation

reduce the pressure.
Softener resins may degrade in the pres-

ence of chlorine or chloramines above 2
ppm. If you have chlorine or chloramines
in excess of this amount, you may experi-
ence reduced life of the resin. In these
conditions, you may wish to consider pur-
chasing a whole house carbon filter soften-
er system with a chlorine reducing media.
Contact US Water Systems for Chlorine
and Chloramine removal equipment.
WARNING: Discard all unused parts

and packaging material after installation.
Small parts remaining after the installation
could be a choke hazard.
Installation, Operation and Maintenance Manual