Proper Installation - US Water Systems FSF-150 Owner's Manual

3
This water filter system must be properly installed and located in accordance with the
Installation Instructions before it is used.
Do not install or store where it will not be

exposed to temperatures below freezing or
exposed to any type of weather. Water
freezing in the system will break it. Do not
attempt to treat water over 100°F.
Do not install in direct sunlight. Excessive

sun or heat may cause distortion or other
damage to non-metallic parts.
Properly ground to conform with all gov-

erning codes and ordinances.
Use only lead-free solder and flux for all

sweat-solder connections, as required by
Overall
System
Inlet-Outlet
Connection
Height
A B

Proper Installation

Model
FSF-150
FSF-200
FSF-250
FSF-300
FSF-400
FSF-500
Tank
C
state and federal codes.
Maximum allowable inlet water pressure is

125 psi. If daytime pressure is over 80 psi,
night time pressure may exceed the maxi-
mum. Use a pressure reducing valve to
reduce the flow if necessary.
WARNING: Discard all unused parts and

packaging material after installation. Small
parts remaining after the installation could
be a choke hazard.
Tank Size A
10" X 54" 60.25"
12" X 52" 58.25"
13" X 54" 60.25"
14" x 65" 72.25"
16" x 65" 72.25"
18" x 65" 72.25"
B C
57.25" 10"
55.25" 12"
57.25" 13"
68.25" 14"
68.25" 16"
68.25" 16"