Dell S3048-ON Configuration Manual page 957

If the next-hop IP in a static route VRF statement is VRRP IP of another VRF, this static route does not get installed on the VRRP master.
VRF supports some routing protocols only on the default VRF (default-vrf) instance.
VRF and whether they are supported on all VRF instances or only the default VRF.
NOTE: To configure a router ID in a non-default VRF, configure at least one IP address in both the default as well as the non-
default VRF.
Table 94. Software Features Supported on VRF
Feature/Capability
802.1x protocol on the VLAN port
OSPF, RIP, ISIS, BGP on physical and logical
interfaces
Dynamic Port-channel (LACP) on VLAN
port or a Layer 3 port
Static Port-channel as VLAN port or a Layer
3 port
Encapsulated Remote Port Monitoring
BFD on physical and logical interfaces
Multicast protocols (PIM-SM, MSDP)
PIM-DM
Layer3 (IPv4/IPv6) ACLs on physical
interfaces and LAGs
PBR, L3 QOS on physical interfaces and
LAGs
Layer 3 (IPv4/IPv6) ACLs on VLANs
PBR, L3 QoS on VLANs
IPv4 ARP
sFlow
VRRP on physical and logical interfaces
VRRPV3
Secondary IP Addresses
Basic
Support Status for Default VRF
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
Yes
NOTE: QoS not supported on
VLANs.
Yes
Yes
Yes
Yes
Yes
Yes
Table 1 displays the software features supported in
Support Status for Non-default VRF
Yes
Yes
NOTE: RIP is not supported on non-
default VRF.
Yes
Yes
No
No
Yes
NOTE: MSDP is not supported in
non-default VRF.
No
Yes
NOTE: IPv6 ACLs supported only in
default VRF
No
Yes
NOTE: IPv6 ACLs supported only in
default VRF.
No
Yes
No
Yes
Yes
Yes
Yes
Virtual Routing and Forwarding (VRF) 957