Vlan Interfaces - Dell S3048-ON Configuration Manual

ip address ip-address mask
• Enable the interface.
INTERFACE mode
no shutdown
• The interface is the management interface.
INTEFACE mode
description
Example of the show interface and show ip route Commands
To display the configuration for a given port, use the show interface command in EXEC Privilege mode, as shown in the following
example. To display the routing table, use the show ip route command in EXEC Privilege mode.
Dell#show int gig 1/1
GigabitEthernet 1/1 is up, line protocol is up
Description: This is the Managment Interface
Hardware is Force10Eth, address is 00:01:e8:cc:cc:ce
Current address is 00:01:e8:cc:cc:ce
Pluggable media not present
Interface index is 46449666
Internet address is 10.11.131.241/23
[output omitted]
Dell#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is 10.11.131.254 to network 0.0.0.0
Destination
-----------
*S 0.0.0.1/0
C 10.11.130.0/23
Dell#

VLAN Interfaces

VLANs are logical interfaces and are, by default, in Layer 2 mode. Physical interfaces and port channels can be members of VLANs.
For more information about VLANs and Layer 2, see
NOTE: To monitor VLAN interfaces, use Management Information Base for Network Management of TCP/IP-based internets:
MIB-II (RFC 1213).
NOTE: You cannot simultaneously use egress rate shaping and ingress rate policing on the same VLAN.
Dell Networking OS supports Inter-VLAN routing (Layer 3 routing in VLANs). You can add IP addresses to VLANs and use them in routing
protocols in the same manner that physical interfaces are used. For more information about configuring different routing protocols, refer to
the chapters on the specific protocol.
A consideration for including VLANs in routing protocols is that you must configure the no shutdown command. (For routing traffic to
flow, you must enable the VLAN.)
NOTE: You cannot assign an IP address to the default VLAN, which is VLAN 1 (by default). To assign another VLAN ID to the
default VLAN, use the default vlan-id vlan-id command.
To assign an IP address to an interface, use the following command.
• Configure an IP address and mask on the interface.
Gateway
-------
via 10.11.131.254, Gi 1/1
Direct, Gi 0/48
Layer 2
Dist/Metric Last Change
----------- -----------
1/0 1d2h
0/0 1d2h
and Virtual LANs (VLANs).
Interfaces 331