Table of Contents
Advertisement
Figure 80. MSDP with Anycast RP
Configuring Anycast RP
To configure anycast RP, use the following commands.
1
In each routing domain that has multiple RPs serving a group, create a Loopback interface on each RP serving the group with the
same IP address.
CONFIGURATION mode
interface loopback
2
Make this address the RP for the group.
CONFIGURATION mode
ip pim rp-address
3
In each routing domain that has multiple RPs serving a group, create another Loopback interface on each RP serving the group with a
unique IP address.
CONFIGURATION mode
interface loopback
Multicast Source Discovery Protocol (MSDP)
491
- Quick Links:
- Accessing the Command Line
- Cli Modes
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
